Nibe F730 - The Heat Pump: Core Functionality

Removing the covers
FRONT COVER
LEK
LEK
4
1
2
3
1.
Remove the upper panel by pulling it straight out.
2.
Remove the screws from the lower edge of the
front panel.
3.
Lift the panel out at the bottom edge and up.
4.
Pull the panel towards yourself.
SIDE COVERS
LEK
LEK
LEK
The side covers can be removed to facilitate the install-
ation.
1.
Remove the screws from the upper and lower
edges.
2.
Twist the cover slightly outward.
3.
Move the hatch backwards and slightly to the side.
4.
Pull the cover to one side.
5.
Pull the hatch forwards.
Removing parts of the
insulation
Parts of the insulation can be removed to facilitate the
installation.
INSULATION, TOP
1.
Disconnect the cable from the motor and remove
the motor from the shuttle valve as illustrated.
L
E
K
L
E
K
LEK
LEK
A
B
2.
Grip the handle and pull straight out as illustrated.
L
E
K
LEK
NIBE F730Chapter 2 | Delivery and handling10