Nibe SMO S40 - 9 Control - Menus; Menu 1 - Indoor Climate

Menu 1 – Indoor climate
OVERVIEW
1.1.1 - Heating1.1 - Temperature
1.1.2 - Cooling
1
1.1.3 - Humidity
1
1.2.1 - Fan speed
1
1.2 - Ventilation
1
1.2.2 - Night cooling
1
1.2.4 - Demand-controlled ventilation
1
1.2.5 - Fan return time
1
1.2.6 - Filter cleaning interval
1
1.3 - Room sensor settings
1.3.3 - Room units
1
1.3.4 - Zones
1.4 - External impact
1.5 - Climate system name
1.30.1 - Curve, heating1.30 - Advanced
1.30.2 - Curve, cooling
1.30.3 - External adjustment
1.30.4 - Lowest supply heating
1.30.5 - Lowest supply cooling
1.30.6 - Highest supply heating
1.30.7 - Own curve
1.30.8 - Point offset
1
Consult the accessory’s Installer Manual.
MENU 1.1 TEMPERATURE
You make temperature settings for SMO S40 here.
MENU 1.1.1, 1.1.2 - HEATING AND COOLING
Heating and cooling
Set the temperature (with room sensor installed
and activated):
Heating
Setting range: 5 – 30 °C
Cooling (accessory required)
Setting range: 5 – 35°C
The value in the display appears as a temperature in °C,
if the zone is controlled by a room sensor.
Caution
A slow climate system, such as underfloor
heating, may be unsuitable for controlling with
room sensors.
Setting the temperature (without room sensors
activated):
Setting range: -10 – 10
The display shows the set value for heating/cooling
(curve offset). To increase or reduce the indoor temper-
ature, increase or reduce the value in the display.
NIBE SMO S40Chapter 9 | Control – Menus38
9 Control – Menus