Nibe SMO S40 - 2 Delivery and Handling; Mounting

Mounting
NOTE
For wall mounting, use screws (and any plugs)
suitable for the surface.
Use all mounting points and install SMO S40 upright flat
against the wall without any part of the control module
protruding beyond the edge of the wall.
Leave at least 100 mm free space around the control
module to facilitate access and cable routing on installa-
tion and service.
Caution
Screws for removing the front cover are
reached from underneath.
SMO S40
1. Remove the hatch, by unscrewing the screws in the
bottom edge. Angle out at the bottom edge and unhook
the cover at the upper edge.
SMO S40
2x
2. Remove the display by moving it to the left. Detach the
cable from the lower edge.
3. Mark the position of the two upper screws using a pen.
Screw in the upper two screws.
4. Hook onto SMO S40 the screws in the wall.
2x
NIBE SMO S40Chapter 2 | Delivery and handling8
2 Delivery and handling