Menu 3 - Info
OVERVIEW
3.1 - Operating info
3.2 - Temperature log
3.3 - Energy log
3.4 - Alarm log
3.5 - Product info, summary
3.6 - Licences
MENU 3.1 - OPERATING INFO
Information about the installation’s current operating
status (e.g. current temperatures) can be obtained here.
In multi-installations, with several interconnected heat
pumps, information about these is also shown in this
menu. No changes can be made.
MENU 3.2 - TEMPERATURE LOG
Here you can see the average temperature indoors week
by week over the past year.
The average outdoor temperature is only shown if a
room temperature sensor/room unit is installed.
In installations with ventilation accessories and no room
sensors (BT50), the exhaust air temperature is also dis-
played.
MENU 3.3 - ENERGY LOG
Number of months
Setting range: 1 – 24 months
Number of years
Setting range: 1 – 5 years
Here, you can see a diagram showing how much energy
SMO S40 supplies and consumes. You can select which
parts of the installation will be included in the log. It is
also possible to activate display of indoor and/or outdoor
temperature.
Number of months: Select how many months to show
in the diagram here.
Number of years: Select how many years to show in
the diagram here.
MENU 3.4 - ALARM LOG
To facilitate troubleshooting, the installation's operating
status at the time of an alarm is stored here. You can
see information for the 10 most recent alarms.
To view operating status in the event of an alarm, select
the relevant alarm from the list.
MENU 3.5 - PRODUCT INFO, SUMMARY
Here, you can see general information about your sys-
tem, such as software versions.
MENU 3.6 - LICENCES
You can view licences for open source code here.
NIBE SMO S40Chapter 9 | Control – Menus44
To Next Page
Loading...
