21
Transmitter Programming
Once you have your Mighty Mule transmitter programmed,
consult your vehicle's HomeLink instructions section for
HomeLink programming.
WARNING: Changes, modications or adjustments not expressly
approved by Nice North America LLC could void the user’s authority to
operate this equipment. There Are No User Serviceable Parts.
3
4
ON/OFF Switch
Replace and secure back cover of the opener remote.
NOTE: The process for programming any wireless accessory
in the same process as erasing that accessory. There is
no indication that the accessory has been programmed or
erased. Make sure to test the accessory before programing,
because you may unintentionally erase it.
Turn off control box. Press and hold a transmitter button while sliding
the ON/OFF switch to the ON position. Continue to hold transmitter
button for 8 - 10 seconds. You will hear a single or a series of beeps,
followed by a pause then a single beep. Release transmitter’s button.
Your personal code is now programmed.
NOTE: The button you chose will be the button used to operate your
system.
• An innite number of the transmitters can be used, provided that
the dip switches are set to match one another.
Remove back cover of the opener remote. Flip opener remote over. Use small screwdriver to move switches
to random positions. If you have more than one transmitter, now
is a good time to set them all with the same code.
1
1 2 3 4 5 6 7 8 9
2
Programming an FM135 Transmitter
All Mighty Mule transmitters are set to a standard code at the factory. However, for your safety and security, we strongly
recommend that you replace the factory setting with your own personal code. Follow the directions below:
To Next Page
Loading...
