30
If you have a question about any special order item, call 1-800-543-4283
The contents of all material available on this installation manual are copyrighted by Nice North America LLC (“Nice North America”), unless otherwise indicated. All rights are reserved
by Nice North America, and content may not be reproduced, downloaded, disseminated, published, or transferred in any form or by any means, except with the prior, written permis-
sion of Nice North America. Any reprinting of Nice North America publications is by permission only. Copyright infringement is a violation of federal law.
Mighty Mule¨, E-Z Gate¨, Nortek Security and Control¨, “Dual Sense Technology” are registered trademarks of Nice North America LLC, America’s DIY Automatic Gate Openers is a
trademark of Nice North America LLC and are the exclusive property of Nice North America LLC (“Nice North America”).
All rights are reserved by Nice North America, and these marks may not be used, in any for without the prior, written permission of Nice North America.
Low Voltage Wire (RB509)
The 16 gauge, stranded, dual conductor Low Voltage Wire is for connecting the AC powered transformer, or the
Solar Panel to the control board. Also used for the connection of accessories, such as locks, keypads, push buttons
and other wired control devices. This specially designed wire is UV treated, PVC coated and ready for direct burial.
Available in 1000’ rolls or special lengths.
Replacement Transformer (RP1010)
Standard 19V 2A, DC power supply for maintaining the battery with the Mighty Mule gate operator.
Wireless Entry Intercom / Keypad (MM136)
Allows owner to screen guest at the gate before allowing access to the property. Keypad also allows owner to give
up to 25 programmable entry codes to family, friends or approved delivery personnel. Codes can be permanent or
temporary. Up to 500 feet reception.
Additional base stations available (MM136B).
Garage Door Receiver (RB709U-NB)
The Garage Door Receiver allows you to use the same 2 button Mighty Mule entry transmitter to operate your gate
operator and your garage door operator. Compatible with most garage door operators.
Driveway Alarm (FM231)
This device alerts you of vehicles entering your driveway (with or without an automated gate). The indoor base
station signals you with a door chime when a vehicle passes the driveway sensor.
Wireless Driveway Vehicle Sensor (FM130)
Automatically activates gate operator “Hands-Free” when a vehicle exits the property. 100 ft. range between
transmitter and receiver. Easy installation.
To Next Page
Loading...
Need help?
General
