Nice RMF3004 - Common Menus

16
13- COMMON MENUS
TIME OUTPUTS [S1 to S8] (500* to 60000 ms)
Sets, in milliseconds, the retention time of the selected outputs (relays).
SCANNER FUNCTION [L1, L2, L3, L4] (TX*, CT, BM, TP)
It congures, in each channel, the type of device to be identied during acti-
vation, being TX = remote control, CT = RFID card, BM = biometrics and TP =
Passive Tag.
The following menus are present in all modes, with the exception of IO MODULE
mode. Although the DISPLAY menu is not visible in the REC TX+TP and REC
TX+CTWB modes, the options can be congured with the aid of the PC Software.
A) INPUTS MENU
DOOR ALARM [1, 2, 3, 4] (o󰀨*, 15, 60, 120 s)
It determines the time, in seconds, of activation of the door sensor to identify
the “open door” event to the MG 3000 Module . If the sensor changes state wi-
thout a previous activation, the system will identify the event as a “door violated”
(tampering).
E2+E3 = PASSAGE [1, 2, 3, 4] (No*, Yes)
Enables passage identication using 2 sensors (passage with
direction).
Note: if this option is enabled, the corresponding channel’s door sensor will be
disabled.
INPUTS FUNCTION (TX*, TP)
Note: For REC TX+TP mode only.
Determines whether the digital inputs will work with REC TX mode or PASSIVE
Tag mode.
INPUTS FUNCTION (TX*, CTW)
Note: For REC TX+CTWB mode only.
Determines whether the digital inputs will work with REC TX mode or REC
CTWB mode.
EVENT BYPASSED (No*, Yes)
Enables remote control access event sending to the MG 3000 Module if the
channel is bypassed by the digital input.
BUTTON INPUT [L1, L2, L3, L4] (B*)
PASSAG SENSOR [L1, L2, L3, L4] (A*, F)
DOOR SENSOR [L1, L2, L3, L4] (A*, F)
SENSOR BYPASS [L1, L2, L3, L4] (A*, F)
Determines the idle state of the 16 digital inputs, as follows:
B -> Button -> Always normally open (input activated with GND)
- ENGLISH -
72