Nice TTD0110 - Programming the Locking and Unlocking of the Memory; Using the External Button; Using the Memorised Transmitter

EN
English – 11
4.5.2 - Using “External Button”:
01.
OFF
ON
green
LED
3 sec. =
02.
green
LED
3 sec. =
03.
green
LED
3 sec. =
at the 2nd
04.
Adjusting the brightness of the lamp to the desired
value using the external push button:
1st long press on the external button
= increase in brightness until you release the button
2nd long press on the external button
= decrease in brightness until you release the button
CAUTION!
= “Toggle” function (ON/OFF)
05.
=
5 seconds
2
+
desired light
intensity value
06.
select the desired level
Level 1
x 1
Level 2
x 2
Level 3
x 3
Level 4
x 4
07.
5 seconds
green LED +
no. of ... flashes according to
the chosen level
08.
green LED
3 sec. =
09.
2
green LED: memorising OK
4.6 - Programming the locking and unlocking of the memory
4.6.1 - Using “Memorised Transmitter”:
This procedure can only be done using a transmitter already memo-
rised in “Mode 1”.
01.
1 green LED