Nice TTD0110 - 2 Product Description and Intended Use; 3 Electrical Connections

EN
2 – English
increase the risk of danger or malfunction. If this were to happen,
stop installation immediately and contact Customer Service.
2 - PRODUCT DESCRIPTION AND INTENDED USE
TTD0110 is a 1-10 Volt voltage regulator which drives the power out-
put of power supply units, with dimmer output, for lamps. Any other
use is improper and prohibited.
It is equipped with a radio receiver operating at a frequency of 433.92
MHz with “rolling code” encoding.
It can be controlled with Nice compatible products (Table 1) and with
an external push button to switch on and off and adjust the light inten-
sity of the lamp.
TABLE 1
Series Model Buttons Programming Function
Nice Era Era P
Mode 1
(section 4)
Slider
(section 4)
Era W
Era MiniWay
Era One
Mode 2
(section 4)
Era Inti
NiceWay NiceWay
Mode 1
(section 4)
Nice Ergo Ergo
Nice Flor Flor-m
Mode 2
(section 4)
Nice Very Very VR
Mode 1
(section 4)
Nice
Home
Touch HSTS2 display
Mode 1
(section 4)
HSTX8
Mode 2
(section 4)
3 - ELECTRICAL CONNECTIONS
Special warnings:
• The product is subjected to hazardous voltage: therefore,
only open the housing and make connections with the power
switched off.
• Never cut the antenna cable, because it is subject to hazard-
ous voltage.
In order to make the electrical connections, you need to open the
TTD0110 (Fig. 1) and then proceed as shown in Fig. 2 and 3(complete
example of electrical connection):
1