Nice TTD0110 - Transmitter Recognition Procedure; Using the First Transmitter (Empty Memory)

EN
6 – English
ON
CONNECT POWER
LAMP ON
LAMP OFF
DESIRED VALUE
FOR THE BRIGHTNESS OF THE LAMP
PRESS BRIEFLY
PRESS AND HOLD THE BUTTON
ON THE TRANSMITTER
PRESS AND HOLD THE BUTTONS ON THE
TRANSMITTER AT THE SAME TIME
RELEASE THE BUTTON (OR THE BUT-
TONS) ON THE TRANSMITTER
- - -
TRANSMITTER BUTTONS
1
2
3
4
-
1
2
3
4
-
1
2
3
4
...
TRANSMITTER BUTTONS
BRIEFLY PRESS THE DESIRED BUTTON
ON THE TRANSMITTER
PRESS AND HOLD THE DESIRED BUT-
TON ON THE TRANSMITTER
VIEW / SELECT
WAIT FOR...
2 seconds
WAIT FOR A PRECISE TIME
BRIEFLY PRESS THE EXTERNAL BUTTON
PRESS AND HOLD THE EXTERNAL BUT-
TON
RELEASE THE EXTERNAL BUTTON
4.3 - Transmitter recognition procedure
4.3.1 - Using the “First Transmitter” (Empty Memory)
This procedure allows you to associate a transmitter to the dimmer in
“Mode 1”.
01.
OFF
2 seconds
ON
2
Green LED
02.
within 5
seconds
for 8 seconds
03.
2
green LED: memorising OK
2 red LED: memorising NOT CONCLUDED
in this case, repeat the procedure from the beginning