DIGITAL AIR MICROMETER USERS MANUAL (Second Edition)
7
CHAPTER 3 PROCEDURE UP TO MEASUREMENT
Procedures up to the measurement corresponding to each condition are mentioned in this chapter.
3.1 For normal cases
Shown here is the procedure up to measurement for normal cases.
Turn ON compressed air
Turn ON power
Switch to master calibration
mode (master calibration)
Master calibration
Measurement
Supply of compressed air to the main body
Please refer to [Chapter 6, 6.2 Preparation] for details
• Supply of power to the main body
Please refer to [Chapter 6, 6.3 Starting] for details
• Start at measurement mode
Please refer to [Chapter 6, 6.2 Preparation] for details
• Switch from measurement mode to master calibration mode
Please refer to [Chapter 4 Master Calibration] for details
Please perform master calibration regularly (every 2 hrs.).
Please refer to Chapter 4 Master calibration for details
After finishing master calibration, switch to measurement mode.
• Measurement is possible
Please refer to [Chapter 5 Measurement] for details
• Record the master value to the main body
Please refer to [Chapter 4 Master Calibration] for details
To Next Page
Loading...