DIGITAL AIR MICROMETER USERS MANUAL (Second Edition)
8
3.2 For work tolerance (judgment limits) change cases
Shown here is the procedure up to measurement wherein work tolerance is changed.
Turn on compressed air
Turn ON power
Switch to settings mode
Change settings
Switch to master
calibration mode (master
calibration)
Master calibration
Measurement
• Switch from measurement mode to settings mode
Because of work tolerance change, change the judgmen
limit values.
Settings value change can be done in setting mode.
Please refer to [Chapter 6, 6.4 Settings] for details.
• Switch to measurement mode after finishing settings change
Please refer to [Chapter 6, 6.4 Settings] for details.
• Change the judgment limit values at settings mode
Please refer to [Chapter 6, 6.4 Settings] for details.
To Next Page
Loading...