14 Unidrive M702 / HS72 Control Getting Started Guide
Issue Number: 4
2. Select the discovered drive.
3. Select the ‘Online’ icon to connect with the drive. When a successful connection is made the icon
will be highlighted orange.
4. Select ‘Set mode and region’.
If the required control mode is highlighted in the ‘Drive Settings’ dialog, then:
• Change the supply frequency, if required and select ‘Apply’, otherwise select ‘Cancel’.
• Select ‘Default parameters’ from the Dashboard and in the ‘Default Parameters’ dialogue, select
‘Apply’
If the required control mode is not highlighted in the ‘Drive Settings’ dialog then:
• Select the required mode and supply frequency.
• Select ‘Apply’.
5. Select ‘Setup’ and perform the steps highlighted (dotted lines indicate a step which may not need
to be performed (see below):
To Next Page
Loading...
