Nidec Unidrive M400 series User Manual

30 Unidrive M400 Quick Start Guide
Issue Number: 8
* Setting Pr 00.007 to 0.0 will disable slip compensation.
** Following a rotating autotune, Pr 00.009 is continuously written to by the drive, calculated from the value of Stator
Inductance (Pr 05.025). To manually enter a value into Pr 00.009, Pr 05.025 will need to be set to 0. Refer to the
description of Pr 05.010 in the Parameter Reference Guide for further details.
*** If this parameter is read via serial communications, it will show pole pairs.
00.086 Output Voltage 0 to 325 V or 0 to 650 V RO Num ND NC PT FI
00.087 Motor Rpm ±33000.0 rpm RO Num ND NC PT FI
00.088 Current Magnitude 0 to Drive Maximum Current A RO Num ND NC PT FI
00.089
Torque Producing
Current
±Drive Maximum Current A RO Num ND NC PT FI
00.090
Digital I/O Read
Word
000000000000 to 111111111111 RO Bin ND NC PT
00.091 Reference On Off (0) or On (1) RO Bit ND NC PT
00.092 Reverse Select Off (0) or On (1)
RO Bit ND NC PT
00.093 Jog Select Off (0) or On (1) RO Bit ND NC PT
00.094 Analog Input 1 ±100.00 %
RO Num ND NC PT FI
00.095 Analog Input 2 ±100.00 %
RO Num ND NC PT FI
RW
Read /
Write
RO
Read
only
Num
Number
parameter
Bit
Bit
parameter
Txt Text string Bin
Binary
parameter
FI Filtered
ND
No
default
value
NC
Not
copied
PT
Protected
parameter
RA
Rating
dependent
US User save PS
Power-down
save
DE Destination
Parameter
Range
() Default ()
Type
OL RFC-A OL RFC-A

Nidec Unidrive M400 series Specifications

General

Brand	Nidec
Model	Unidrive M400 series
Category	Controller
Language	English