What to do if the display and presented chart disappear suddenly on my Nidek Medical Equipment?
This indicates that the RT-3100 has entered power saving mode. To restore the display, simply press any key.
What to do if none of the keys on the control box function on my Nidek Medical Equipment?
If any abnormalities occur and none of the keys on the control box are functioning, turn the main switch of the system table off, and then turn it back on again.
What to do if the refractor does not start even though the power is turned on in Nidek Medical Equipment?
First, make sure that the power cord is properly connected to a wall outlet. Also, confirm that the system table is turned on.
What to do if pressing the print button does not print the result on Nidek Medical Equipment?
Here are a few things to check: * Replace the printer paper. * Make sure that the Printer parameter is not set to No. * Confirm that the printer paper is loaded with the correct side up.
Why does 'Setup data is initialized' appear on my Nidek Medical Equipment?
This message appears because the internal battery is low. Leave the power on for several hours to allow the battery to charge. Also, contact NIDEK or your authorized distributor.
What to do if I receive incorrect responses from the touch-screen panel of my Nidek Medical Equipment?
Calibrate the touch-screen panel.
Why data cannot be read even though the Eye Care card is inserted in my Nidek Medical Equipment?
Data cannot be read if: * An auto ref/keratometer has no AR measurement data. * The right or left was not specified by the lensmeter. * When any error occurs while data is written with an auto refractometer or lensmeter, clean its card reader and rewrite the data to the Eye Care card.
General| Brand | Nidek Medical |
|---|---|
| Model | RT-3100 |
| Category | Medical Equipment |
| Language | English |
To Next Page
