Connection with Display
To realize simulcast of demonstration contents on both the display and the screen, connect
display output signal output port of the projector with external display by the following
instructions:
Connection of the projector with a display:
1. Connect the projector with a computer, as shown in "Connection with Computer" in page
13.
2. Prepare a proper VGA cable (only one cable provided), and connect one end with D-Sub
input port of video display.
Please prepare a VGA - DVI-A cable in case the display has DVI input port, and connect one
end of DVI with DVI input port of video display.
3. Connect the other end of the cable with display output port of the projector.
• Only when input signal is from COMPUTER-1 or COMPUTER-2 port, the output signal
of MONITOR-OUT port can be in service. When the projector is powered on, the output
signal from display output port depends on the input signal from computer input-1 or
computer input-2 ports.
• To use the connection mode with the projector in standby mode, ensure that display output
function in system setting: advanced >standby setting menu has been enabled.
To Next Page
Loading...