Nierbo UT300 - Display Settings; Image Adjustments and 3 D Functionality

24
User color has 6 (RGBCMY) colors for adjustment. Each color enables the adjustment of range,
hue, saturation and gain independently by personal preference.
Display
Wall Color Correction
Select wall color after enabling wall color.
Width-Height ratio
Select to keep the picture suitable for the screen:
• Automatic: adjust image size proportionally to match natural resolution of the projector in
horizontal or vertical width if you wish to make full use of the screen rather than change width-
height ratio of source image.
• Width: maintain original width-height ratio in image center to keep main distortion of
displayed image distributed at the edge, thus to mitigate image proportion distortion to the
greatest length.
• 4:3: Adjust the image proportionally to display the image in 4:3 width-height ratio in screen
center.
• 16:9: Adjust the image proportionally to display the image in 16:9 width-height ratio in screen
center.
Automatic Trapezoidal Correction
Automatic correction of trapezoidal distortion caused by projection angle.
Trapezoidal Distortion Correction
Manual Correction of distorted image caused by projection angle.
Press Trapezoidal Correction / on the projector or remote controller to display trapezoidal
correction page.
Press to correct trapezoidal distortion at image top.
Press to correct trapezoidal distortion at image bottom.
3D
The projector supports 3D function to enable realistic experience of 3D films, videos and motion
events through the representation of image depth. Wear 3D glasses to watch 3D image.
3D Mode
Use the function to select proper 3D mode in case the projector cannot identify 3D mode.
In case 3D signal is input from HDMI 1.4a compatible equipment, the projector will detect 3D
synchronizing information in the signal, and will project image in 3D format automatically upon
detection. Otherwise, select 3D synchronizing format manually for the projector before correct
projection of 3D image.
Notes
• 3D mode is available when 3D Synchronization is set as "Enabled".
• Default setting is "Automatic" in case input source is HDMI.
• Default setting is "Parallel" in case input source is video or computer. "Automatic" will be unavailable.
• The luminance of projection image will be lowered.