Safety Instructions
Before the use of the projector, please read and take good care of all the guidance and instructions
for future reference.
1. Instructions for reading guidance
Please read all the guidance and instructions for safety and use before using the equipment.
2. Notice and warning
Please follow all the notices and warnings in the guidance and instructions for use.
3. Cleaning
Pull out power plug of the projector from wall-mounted power socket before cleaning. Wipe
projector shell with wet cloth. Please do not use liquid or spray detergent.
4. Accessory
Do not put the project on unstable cart, rack or desk. The product may drop down to cause
serious damage.
Put plastic wrappage (of the projector, accessories and optional parts) out of reach by children
to prevent death by suffocation. Please pay special attention for infants.
5. Ventilation
The projector is equipped with intake and exhaust holes. Please do not block the openings or
put any
article near the holes to prevent possible internal heat accumulation, which may cause picture
quality degradation or damage to the projector.
6. Power supply
Please confirm that working pressure of the projector is the same with the voltage of your local
power supply.
7. Repair
Please do not try to repair the projector by yourself. Do entrust professional technicians for
repair.
8. Component replacement.
When necessary to replace components, please do use the components for replacement
designated by the manufacturer. Unauthorized replacement may cause fire accident, electric
shock or other hazards.
9. Steam condensation.
Do not use the projector immediately after moving the projector from a cold place to a warm
place. Moisture may condense at the lens and internal key components in case the projector is
in temperature change. To prevent damage to the projector, please wait for at least 2h before
use in case of sharp or sudden temperature change.
The projector only applies to safe use below altitude 2,000m, and the use above altitude
2,000m may cause safety hazard.