Nikon 1 V1 User Manual

60
t
A
Optional Flash Units
Flash units other than the SB-N5 can not be used. Detailed instructions
may be found in the manual provided with the flash unit. Objects close
to the camera may be overexposed at high ISO sensitivities.
A
The Flash/Capture-Illuminator Status Indicators
If the flash status or capture-illuminator status indicator on the rear of
the flash unit blinks, one of the following errors may have occurred:
Display Description
The flash status indicator blinks for
about three seconds after a photo-
graph is taken.
The flash has fired at full power and
the photograph may be underex-
posed. Try reducing the distance to
the subject or increasing ISO sensi-
tivity (0 131).
The flash or capture status indicator
blinks once a second.
Continuous use has caused the tem-
perature of the flash unit to rise and
the unit has been disabled to protect
the flash. Turn the unit off and wait
for it to cool.
The flash and capture status indicators
blink once every two seconds.
A data transfer error has occurred.
Check that the flash unit is correctly
attached.
The flash status indicator blinks eight
times a second.
An error has occurred in the unit’s
internal circuitry. Turn the camera
off, remove the flash unit, and take
the camera and flash unit to a Nikon-
authorized service center for consul-
tation.

Nikon 1 V1 Specifications

General

Sensor Type	CMOS
Sensor Size	13.2 x 8.8 mm
Effective Pixels	10.1 million
Screen Resolution	921, 000 dots
Dimensions	113 x 76 x 43.5 mm
Camera Type	Mirrorless
Lens Mount	Nikon 1 mount
Focal Length Multiplier	2.7x
Shutter Speed	30 - 1/16000 sec
Storage Media	SD/SDHC/SDXC
ISO Sensitivity	ISO 100-3200, expandable to 6400
Autofocus System	Hybrid AF with contrast and phase detection
Continuous Shooting Speed	Up to 60 fps
Viewfinder	Electronic (1.44M-dot)
Screen Size	3.0 inches
Video Recording	Full HD 1080p at 30fps
Battery Life	Approx. 350 shots (CIPA)
Weight	294 g (body only)