Chapter 6 Specifications
29
Chapter 6 Specifications
6
Specifications
This chapter describes the specifications and rating of this product.
6.1 Principles of Operation
The D-LEDI fluorescence LED illumination system controls on/off and brightness operations of four LEDs of
different wavelengths to provide the light for an illumination device or microscope through the light-emitting
hole. Operations are performed by using the D-LEDI-C remote control pad or the NIS-Elements application
installed on a PC connected to this product via USB.
When this product is connected to the microscope Ti2-E, it can be operated from the Ti2 Control application
installed on a smart device.
When an external trigger generation device is connected, on/off of the LEDs of this product can be controlled
by external triggers.
Intended Use
This product is intended for providing LED illumination to fluorescent microscopy of a microscope.
6.2 Physical Properties
Fluorescence LED illumination system
Model name D-LEDI
External dimensions and
mass (reference)
External dimensions: 104 (W) x 128 (H) x 160 (D) mm (excluding protrusions)
Mass (reference): Approx. 1.5 kg
Electrical shock
protection class
Class I
Environmental conditions Operation: Temperature: 0 to +40°C
Humidity: 60% RH max. (at +40
°C) (no condensation)
Storage and Transport: Temperature: -20 to +60
°C
Humidity: 90% RH max. (no condensation)
Altitude: 2000 m max.
Pollution: Degree 2
Overvoltage category: Category II
Indoor use only
Remote control pad
External dimensions and
mass (reference)
External dimensions: 90 (W) x 52 (H) x 130 (D) mm (excluding protrusions)
Mass (reference): Approx. 0.2 kg
Cable length Approx. 2.7 m
To Next Page
Loading...