Nikon Eclipse Ci-E - Page 81

Chapter 3 Assembly
69
Chap. 3
Assembly
3
Attach the condenser.
(1) Turn the coarse focus knob until the elevating
section is brought to the upper limit.
(2) Turn the condenser focus knob until the condenser
holder reaches the bottom.
(3) Insert the condenser, adjust it to face the front, then
secure it in place with the tool.
(4) Turn the condenser focus knob until the condenser
holder reaches the top.
TORQU E
CLAMP
P
O
WER
0
90
80
70
60
50
40
30
20
10
0.9
0.7
0.6
0.5
0.8
0.1
0.2
Attaching the condenser
When using the motorized swing-out condenser,
secure the condenser cable using the three
protrusions (as shown), and then connect the cable
to the swing-out condenser connector on the main
body.
0
90
80
Motorized swing-out condenser cable
CAUTION
Make sure that the power to the microscope is turned
OFF before connecting the condenser cable.
Connect the motorized swing-out condenser cable
to the microscope main body so that a wider
protrusion among those at the end of the plug faces
the front (facing the observer).
Motorized swing-out condenser
Condenser focus knob
Condenser clamp screw
(use a tool)
Swing-out
condenser
connecto
r
Protrusion
Protrusions
With a wider
protrusion on
the front