Chapter 3 Assembly
70
Chap. 3
Assembly
4
Attach the tube.
Place the tube on the microscope arm and secure it by
tightening the clamp screw on the arm.
Attaching the tube
Using the eyelevel riser
Place the eyelevel riser on the microscope arm and
secure it by tightening the clamp screw on the arm.
Attach the tube on the eyelevel riser and secure it
by tightening the clamp screw on the eyelevel riser
using a tool.
Attaching the eyelevel riser
5
Attach eyepieces.
Make sure the notch on the eyepiece side and the
protrusion of the eyepiece sleeve are aligned, then insert
the eyepieces.
Attaching eyepieces
Notch on eyepiece
The eyepiece has a notch to prevent rotation.
When attaching, match the notch with the
protrusion on the eyepiece sleeve. Otherwise,
eyepiece is not attached to the correct position.
6
Mounting the spacer for the nosepiece (only when using the spacer for the nosepiece)
Contact your nearest Nikon representative when the spacer for the nosepiece needs to be mounted or removed.
7
Attach the objective.
Screw the objective into the nosepiece. Select the nosepiece address so that the magnification of the objectives
increases as you go from address 1 to 6.
Tube clamp scre
Eyelevel riser
Tube clamp
screw
(use a tool)
Eyelevel riser
clamp screw
Protrusion
Notch
To Next Page
Loading...
