Nikon Eclipse E400 User Manual

)) !-
VE”
© Selecting color tone and brightness
The color tone of the lamp varies according to the voltage. If
the voltage is increased, the color tone of the lamp becomes bluer.
If the voltage is decreased, the color tone of the lamp becomes
tedder. Therefore, in order to obtain the best color reproduction
in color photomicrography, the lamp voltage should be kept
constant. When using daylight-type color film, the standard setup
is to use the color balancing filter (NCB11) and set the Jamp
4)
The
auto-photo
switch
is
used
to
automatically
set
the
standard
lamp
voltage.
If
the
image
on
color
film
shot
with
the
auto-photo
voltage to the standard for photomicrography.
switch
pushed
are
reddish
or
bluish,
finely
adjust
the
voltage
with
the
auto-photo
voltage
selector
switch.
The
center
position
of
the
5-level
slide
switch
is
the
standard
position.
Sliding
the
switch
forward
increases
the
bluish
tint
of
the
light,
while
sliding
the
switch
towards
the
back
increases
the
reddish
tint
of
the
light.
If
this
adjustment
is
not
enough
to
resolve
the
problem,
also
use
commercially available color compensation filters (CC filters).
© Trimming
Loosen the stage rotation clamp screw in order to rotate the stage.
Tighten the clamp screw at the desired position and secure in
position.

Nikon Eclipse E400 Specifications

General

Type	Biological Microscope
Optical System	CFI60 Infinity Optical System
Nosepiece	Quadruple nosepiece
Magnification	40x to 1000x
Power Supply	AC 100-240V, 50/60Hz
Lamp Power	6V 30W
Eyepiece	10x
Objective Lenses	4x, 10x, 40x, 100x
Stage	Mechanical stage
Focus	Coaxial coarse and fine focusing
Condenser	Abbe condenser, N.A. 1.25
Observation Tube	Binocular
Stage Dimensions	134mm
Interpupillary Distance Adjustment	50-75mm
Diopter Adjustment	+/- 5 diopters
Illumination	Built-in Koehler illumination