Nikon Eclipse E400 - Replacing the Microscope Lamp

Auron
@ In order to prevent electric shock and damage to the microscope, always turn off the power switch (flip it to the “ ”
side) and unplug the power cord before replacing the lamp.
@
In
order
to
prevent
burns,
allow
the
lamp
to
cool
before
replacing
it
by
waiting
at
least
30
minutes
after
using.
% Use a 6 V-30 W halogen lamp (PHILIPS 5761).
@
Do
not
touch
the
glass
portions
of
the
lamp
with
your
bare
hands.
Doing
so
will
cause
fingerprints,
grease,
etc.,
to
burn
onto
the
lamp
surface,
reducing
the
illumination
provided
by
the
lamp.
If
you
do
get
any
fingerprints
or
dirt
on
the lamp, wipe it clean.
@
After
replacing
the
lamp,
make
sure
that the
lamp
cover
is
attached
securely.
Never
use
the
lamp
while
its
cover
is
off.
Confirm that the power switch is off (i.e., that it is flipped to the “ >” side).
Securely push the lamp into the socket pin holes as far as it will go. (Do not touch the glass portion of the lamp with your bare
hands.)
Attach the lamp cover securely.