II. Microscopy
31
6. Conduct observation.
1) Press the “OBJECTIVE” key on the remote control pad to
select the desired magnification.
2) Move the ND filter on the dia-illuminator in and out of the
optical path to adjust the brightness of the view field.
Supplementary information
If precise color fidelity is not required, brightness can
be adjusted by varying the lamp voltage using the
“brightness adjustment dial” on the left side of the
microscope.
7. Upon the completion of microscopy
1) Turn off the power switch of the HUB controller. (Flip the
switch to {.)
2) Turn off the power switch of the power supply. (Flip the
switch to {.)
3) After the lamp mounting section cools, place the vinyl cover
on the microscope.
To Next Page
Loading...
Need help?
General
