19
INSTALLING BATTERIES
1
Pull out and turn battery holder
release knob as shown. 2
Remove battery holder MS-30.
3
Install eight AA-type batteries with
the “+” and “–” terminals positioned
as shown inside the holder.
4
Return battery holder MS-30 to
battery chamber. 5
Turn battery holder release knob
clockwise until it stops.
• To install Ni-MH Battery Unit MN-30,
follow steps 1-2 and 4-5.
Before installing batteries:
• Make sure the power switch is set
at OFF position.
• Use AA-type alkaline or lithium
batteries, or optional Ni-MH
Battery Unit MN-30 with the F5.
• When installing/replacing batteries,
always read “NOTES ON BATTER-
IES”, page 154.
CAUTION: When carrying the battery holder MS-30 removed from the camera
body, remove its batteries or install it in a case to avoid possible short-circuit
caused by contacts with other metal objects.
P400 (E) 02.12.27 6:42 PM Page 19
To Next Page
Loading...
