58
2
Remove finger from ¨ button, and rotate Main-
Command Dial to select desired shutter speed.
Shutter speed indications change in 1/3 steps between 30 sec.
and 1/8000 sec., and flash sync speed of 1/250 sec. (X25o).
• This operation can be performed only with lenses having
a built-in CPU.
• If meter and LCD readout have turned off, turn on again
by lightly pressing shutter release button.
• If “bulb” is set on the camera, selecting the Shutter-
Priority Auto mode will cause buLb to blink—a warning
that the “bulb” setting cannot be used in Shutter-Priority
mode.
SHOOTING IN EACH EXPOSURE MODE
Operation in Shutter-Priority Auto Exposure Mode
1
While pressing ¨ button, rotate Main-Command Dial
until ™ appears in the top LCD panel and S in the
viewfinder.
• When using CPU Nikkor lens other than G-type, make sure to
set lens to its minimum aperture position (largest f-number).
c
The direction that the Main-Command
Dial is turned to increase/decrease
shutter speed can be changed using Custom Setting #6.
See page 88.
P400 (E) 02.12.27 6:42 PM Page 58
To Next Page
Loading...
