Nikon N Series User Manual

3 Getting Started
36 Nikon N Series/K Series Total Station Instruction Manual
3. If you have set the record mode to Confirm (see
Measurement settings, page 51), the Record PT
screen appears after each measurement.
Do one of the following:
– To record the point, press [ENT].
– To return to the BMS, press [ESC].
4. To return to the BMS from the Qcode screen, press
[MODE] or [ESC].
[COD] key
In the BMS, press [COD] to change the default feature code that will appear in the CD
field when you record a point.
Setting the default code
When you press
[COD] in the BMS, a window for
entering the feature code appears.
You can use the
List and Stack softkeys to enter the
code.
Qcode observations
To enter the Quick code observation routine, press the
Qcode softkey.
In this function, you can use the ten numeric keys to
both select a feature code and shoot a point.
To change the measurement mode for the Quick code
observation, press the
Sett softkey.
To assign a new feature code to a numeric key, press [^] or [v] to highlight the code that you want to change. Then
press the Edit softkey.
You can use the DSP softkey to change the values shown in the measurement box, in the same way as you use
the [DSP] key in the Basic Measurement Screen (BMS).
In Quick code measurement, the Rec mode can only be set to Confirm or ALL.

Nikon N Series Specifications

General

Brand	Nikon
Model	N Series
Category	Measuring Instruments
Language	English