Nikon N Series User Manual

3 Getting Started
38 Nikon N Series/K Series Total Station Instruction Manual
To change the settings defined in a target set, highlight the target set in the list. Then
press the
Edit softkey.
Entering a field note
To enter a field note, press
[HOT] to display the HOT
menu. Then either press
[4], or select Note and press
[ENT].
This function can be used at any time on any
observation screen.
Each note can be up to 50 characters.
The note is stored as a CO record in the raw data.
To display a list of previously used notes, press the
Stack softkey. The stack stores the last 20 notes.
Use
[^] or [v] to highlight a note in the list. Then press
[ENT] to select the note.
Setting the default point name
To change the default point name, press
[HOT] to display
the HOT menu. Then press
[5], or select Default PT
and press
[ENT].
This function is available from any observation screen.
Modify the default point name for the next record.
Press
[ENT] to confirm the new default point name. The
new point name is appears as the default PT name on
the input screen.
Type Prism/Sheet
Const –999 to 999 mm
HT –9.990 to 99.990 m
HT can be left blank in the target set. If you leave it blank, the current HT value is always applied to the
measurement.
When a target set is selected, the Type and Const values are copied to both [MSR1] and [MSR2] settings, and to
the measurements in Qcode. If you have specified a value for HT, this value is also copied to the current HT.

Nikon N Series Specifications

General

Brand	Nikon
Model	N Series
Category	Measuring Instruments
Language	English