Nikon SB-26 - Nomenclature; Product View

98
Flash head rotating
lock release lever
LCD panel
See page 26.
Control buttons
See page 26.
Sync/multiple flash terminal
For manual-exposure multiple flash operation.
TTL multiple flash terminal
For TTL-exposure-control multiple flash
operation.
Terminal cover
Keep terminal covered when not in use.
Rotating angle scale
Tilting angle scale
S
D
O
F
F
SB-26
Chapter
1
Nomenclature
Mounting foot locking
wheel
Mount pin
Built-in wide flash adapter
Built-in diffuser card
Flash head
Locks at the front position and the 90˚ position; tilts
up to 90° and down to –7°; rotates 90° to the right
and 180° to the left.
Battery chamber lid
Slide and lift to open.
Flash head tilting lock
release lever
Meter/Feet select lever
(inside battery chamber)
Battery chamber
Accepts four 1.5V AA-type penlight batteries, either
1.5V alkaline-manganese or 1.2V NiCd batteries
(voltage for NiCd batteries varies depending on
manufacturer; maximum permitted is 1.5V).
Autofocus assist illuminator LED
Enables autofocus operation in dim light or total
darkness.
Light sensor for Non-TTL Auto Flash operation
In Non-TTL Auto Flash operation, be careful not to
cover or otherwise obstruct the sensor.
External power source terminal
Accepts power cord of Nikon DC unit
SD-8/SD-7, or Power Bracket Unit SK-6.
Hot-shoe contacts
Mounting foot
Wireless Slave Flash selector
Red-Eye Reduction lamp
Wireless Slave Flash sensor
SB-26 (E) 03.1.14 7:16 PM Page 8