Nikon SB-5000 - Cooling System and Camera-Set Functions; Cooling System Functionality; Functions Configurable on Camera

E-17
E
Functions
En-03
■ Cooling system
The SB-5000’s cooling system effectively cools down the flash head. It
can extend the time before the thermal cut-out function starts operating.
Choose [ON] or [OFF] in the setup menu.
• When it is set to [ON], an operating noise is produced after flash firing. If
this causes problems, set the function to [OFF].
• When it is set to [ON], the batteries may become unusable before the
estimates given (0F-17).
• While the cooling system is operating, the standby function is canceled.
Functions to Be Set on the Camera
The following functions are available when used with cameras so
equipped. Set these functions on the camera. They cannot be set on the
SB-5000 directly.
• For details about camera functions and settings, see the camera user’s
manual.
• Auto FP high-speed sync
• Flash value lock (FV lock)
• Slow sync
• Red-eye reduction
• Rear-curtain sync