nilan Compact P Software Instructions

Service
General settings
Service
↳
Unit start/stop Settings:
Standard setting:
Description:
On / Off
Off
The unit is turned off at the factory to prevent errors
occurring when power is connected.
The installer starts the unit here.
The installer can also turn off the entire unit if
performing service inspection.
↳
User selection programs See settings on the next page under User selection
programs!
↳
Auto reset for external fire alarm Settings:
Standard setting:
Description:
On / Off
Off
Off: This setting is used to stop the unit if the switch is
deactivated. It is used e.g. when connecting a fire
thermostat.
On: Activated if the unit is connected to an external
fire automation system. With this setting, the unit
automatically restarts after having been interrupted
by the fire automation system.
↳
Lock user settings Settings:
Standard setting:
Description:
On / Off
Off
Activating this function locks all user settings,
preventing the user from changing any settings other
than those on the front page of the display. Hence,
installer log on will be needed in order to be able to
change anything.
This function is often used in tenanted properties.
↳
Change password Description: Here it is possible to change the password for setting
by installer.
↳
Enter new password Description: Enter a new password here.
↳
Repeat new password Description: Enter the new password here again to check that it has
been entered correctly.
↳
Save settings Description: Press to save current settings.
↳
Restore last-saved settings Description: Press to restore the last saved settings.
↳
Restore factory default settings Description: Press to restore default settings.
NB: Balancing settings will disappear. Note fan setting
before activating the function.
↳ USB drive Description: For using the USB drive.
↳
Save system configuration to USB Description: The unit's settings can be saved to a USB stick. If
required, they can be used on another unit.
↳
Install system configuration from
USB
Description: It is possible to install a previously-saved system
configuration from the USB. Or it could be a
configuration from another unit.
↳ Save event log to USB Description: It is possible to save the event log from the unit to a
USB stick.
↳
Browse USB Description: See what is on the USB.
36

nilan Compact P Specifications

General

Brand	nilan
Model	Compact P
Category	Heat Pump
Language	English