INSTRUCTIONS FOR USE ENGLISH
9100002290 - SC401 15
09/2017
8. (Only for drive versions) If necessary, adjust the maximum speed with the adjuster (47).
9. To avoid marks or lines on delicate oors, use the “pre wetted” function, which dampens the brush before starting the
operation.
To activate this function, press the push-buttons (42) and (43) together for 10/20 seconds.
NOTE
The “pre wetted” function stays only as long as the push-buttons (42) and (43) are pressed.
10. Adjust the detergent ow by pressing the push-button (43) as necessary, depending on the type of cleaning to be performed.
When the LED is on, it indicates the value in liters per minute of solution ow supplied, as shown in the Figure 4. When the
LEDs are o, the solution ow is stopped.
0.53 (2.0) gpm (l/min)0.18 (0.7)0.08 (0.3)
Figure 4
P100952
11. If necessary, deactivate the vacuum system by pressing the push-button (44, LED o), then press it again to reactivate it (LED
on). To reduce the noise, turn on the vacuum system mute function by pressing the push-button (44).
12. (Only for no drive versions) If necessary, stop the machine and turn the forward speed adjusting handwheel (35) as shown
below:
• Turn it counter-clockwise to increase the forward speed;
• Turn it clockwise to decrease the forward speed.
NOTE
For correct scrubbing/drying of oors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in gure 5.
Figure 5
P100953
CAUTION!
To avoid any damage to the oor surface, turn o the brush when the machine stops in one place.
9100002290(A)09-2017.indb 15 24/10/2017 14:24:03
To Next Page
Loading...
Need help?
General
