INSTRUCTIONS FOR USE ENGLISH
9100002290 - SC401 23
09/2017
FUSE CHECK/REPLACEMENT
NOTE
All machine electrical circuits are protected by auto-resettable electronic devices. The safety fuses activates only in case
of serious damage.
It is recommended to have the fuses replaced by qualied personnel only.
Refer to the Service Manual available at any Advance Retailer.
TROUBLESHOOTING
TROUBLE POSSIBLE CAUSE REMEDY
The motors are not operating; the button LEDs do
not turn on.
The battery connector is disconnected. Connect.
The batteries are completely discharged. Charge the batteries.
The machine does not move.
(Only for drive versions)
The machine is turned on with the ignition key
and by keeping the hands on the presence
sensors.
Turn the ignition key to “0”, then try to start the
machine again with hands o the sensors.
The battery symbol LEDs ash simultaneously. Brush motor overload. Use less aggressive brushes suitable for the
oor to be cleaned.
There are foreign materials (tangled threads,
etc.) preventing the brush from rotating.
Clean the brush hub.
The scrubbing/drying function does not start. The control panel is broken. Replace. (*)
The presence sensors are broken. Replace. (*)
The dirty water vacuuming is insucient.
The recovery tank is full. Empty the tank.
The vacuum grid is clogged or the oat is
stuck closed.
Clean the vacuum grid.
Debris collection lter container clogged. Clean.
The hose is disconnected from the squeegee. Connect.
The squeegee is dirty or the squeegee blades
are worn or damaged.
Clean the squeegee or overturn/replace the
blades.
The tank cover is not properly closed, or the
gasket is damaged.
Correctly close the cover or clean/replace the
gasket.
The vacuum system does not work and the
vacuum system button LED ashes fast.
Vacuum system motor overload. Replace. (*)
The solution ow to the brush is insucient.
Empty detergent solution tank. Rell.
The solution lter is dirty. Clean the lter.
The Detergent System (optional) or the tank is
dirty/furred up.
Clean with the washing cycle.
The squeegee leaves marks on the oor.
There is debris under the squeegee blades. Remove the debris.
The squeegee blades are worn, chipped or
torn.
Overturn or replace the blades.
The squeegee has not been balanced with the
handwheel.
Adjust the squeegee.
(*) This maintenance procedure must be performed by an authorized Advance Service Center.
NOTE
The machine does not work if the battery charger is not on board.
In case of battery charger malfunction, contact an authorized Service Center.
For any further information, contact Advance Service Centers.
9100002290(A)09-2017.indb 23 24/10/2017 14:24:07
To Next Page
Loading...
Need help?
General
