34 - FORM NO. 56043107 - Advolution
™
2710
/ UHR 70-1700
WHEEL DRIVE SYSTEM
STEERING CHAIN REMOVAL AND TENSIONING
WARNING!
Disconnect the battery pack by separating the battery connectors (7) whenever servicing the machine.
1 Turn the master key switch off and separate the Battery Connector Assembly.
2 See Figure 9. From underneath the front of the machine loosen the (4) (A) Screws and push the lower steering column toward the front of the machine.
This is done to separate the Chain
(B) from the Steer Sprocket (C). Service Note: Use a 17mm socket with 3” extension to loosen screws.
3 Remove both Master Links (D) that secure the chain to the steer plate then remove the Chain (B) from the machine.
4 Reassemble parts in reverse order and adjust chain tension so that there is about 3/16”-1/4” (4.7 – 6.4mm) total defl ection with moderate pressure applied at
the Mid-point
(E) (as shown). Service Note: Use a pry bar or shims between the chassis and steer column to help secure the tension adjustment when
tightening the (4) steering column mounting screws.
FIGURE 9
To Next Page
Loading...
Need help?
General
