Nilfisk-Advance Advolution 2710 - Installation of the Burnishing Pad

FORM NO. 56043107 - Advolution
™
2710 / UHR 70-1700 - 9
Advance Advolution 2710 & Nilfisk UHR 70-1700
Rider Burnisher
PM Checklist
Defect Codes
Customer A needs adjustment
B binding
Address C dirty or contaminated
D damaged, bent or torn
City St Zip L leaks
M missing
Model Serial Hours W worn out
Ref
OPERATIONAL INSPECTION ITEMS
OK
Defect Codes
(circle)
Does
Not
Work
1 Steering A B
2 Drive System Pedal Operation (check for Fwd/Rev drive & any neutral creep) A B D
3 Seat Safety Switch D W
4 Electrical Parking Brake (Brake releases when the key is turned on & the drive pedal is
engaged. Note machine should not move when machine is at rest.)
A B W
5 Drive System Performance noisy sluggish
6 Burnishing System Deck & Motor Operation (pad deck raise/lower & pad motor auto
functions)
A B C D
7 Burnishing System performance (even shine) A W
8 Emergency Battery Disconnect Control Knob B D
9 Tilt Steering Mechanism A B
10 Optional Accessories (Headlight, Safety Beacon, Active Dust Control System, Etc.) <----->
11 Battery Charger (auto turn ON & OFF)
12 Main Control Board Special Program Options (Reference SVR Manual 56043107) and
check all applicable program settings. Examples stored error fault codes, diagnostic
SVR test mode, pad pressure settings etc.
A
Ref
VISUAL INSPECTION ITEMS
Comments OK
Defect Codes
(circle)
Does
Not
Work
13 Pad Motor Carbon Brushes (check for wear) C D W
14 Wheel Drive Motor Carbon Brushes (check for wear) C D W
15 Pad Deck Actuator Motor and Pad Drive Deck Levelness Perform a pad pattern
test
A B D
16 Pad Retainer, Pad Driver and Burnishing Pad (check for wear) D M
17 Dust Shroud Assembly Edging and Dust collection Bag D M W
18 Battery Condition (load test, clean & water) D L W
19 Check and Lubricate the Steering Wheel Universal Joint A B D W
20 Steer Chain Tension adjust A B C W
21 Drive and Steer wheels (thread wear) A D W
NOTE: For additional service information see service manual form number 56043107 and
operators manual (English & Spanish) form number 56041634.
WORK COMPLETED BY: ACKNOWLEDGED BY:
Service Technician Signature Date Customer Signature Date