EasyManuals Logo

Nilfisk-Advance S2 User Manual

Nilfisk-Advance S2
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
C344
8
03/2010
S2 / S3
US
Emptying the dust container
WARNING!
Before proceeding with these operations, turn the
vacuum cleaner off and disconnect the plug from
the power socket.
Check the class of the vacuum cleaner.
Before emptying the container it is advisable to clean the lter
(see “Primary lter shaker”).
Machines without HEPA lters are not suitable for
vacuuming hazardous dust
Release dust container (1, Fig. 10), with lever (2),
then remove and empty it.
Make sure the seal is in good condition and
correctly positioned.
Place the container back in position and secure it
again.
Plastic bag
You can use the plastic bags supplied by our sales network
(Fig. 10A) as an alternate collection means.
Primary lter shaker
Automatic primary lter shaker
On models with an automatic primary lter shaker, the lter
shaker will be automatically activated at the start and end of
the operating cycle, respectively after starting the vacuum
cleaner and after all the motors have stopped.
Diagram A (see bottom of page - work phase sequence).
Manual primary lter shaker
Figure 9
In relation to the quantity of material vacuumed and if indicator
(9 - Fig. 5) is red, turn the vacuum cleaner off and use knob
(1 - Fig. 9) of the manual lter shaker.
WARNING!
Stop the vacuum cleaner before using the lter shaker.
Do not shake the lter while the vacuum cleaner is on,
as this could damage the lter.
Wait before restarting the vacuum cleaner, to allow the dust to
settle. Replace the lter element if the indicator remains red
(9 - Fig. 5) even after the lter has been shaken (consult the
“Primary lter replacement” paragraph).
Emergency stopping
Press Stop button (5 - Fig. 5). The vacuum cleaner stops.
WARNING!
The motors and internal components of the vacuum
cleaner will still be electrically powered.
To start the vacuum cleaner again, press the buttons of each
single motor.
10
10 T (s)
2 2 2
STOP
0
I
0
I
0
I
A diagram
Power input
Motor 3
Motor 2
Motor 1
Automatic
lter shaker
Automatic
lter shaker
Stop motors
Operating
time

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance S2 and is the answer not in the manual?

Nilfisk-Advance S2 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelS2
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals