SC3000 26” Disc / 28” Cyl. 9098827000(2)2010-12
27
INSTRUCTIONS FOR USE
ENGLISH
BATTERY CHARGING
NOTE
Charge the batteries when the yellow or red warning light (62) turns on, or at the end of every working cycle.
CAUTION!
Keeping the batteries charged make them last longer.
CAUTION!
When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter.
Check for battery charge at least once a week.
WARNING!
Battery charging produces highly explosive hydrogen gas. Charge the batteries in well-ventilated areas and
away from naked fl ames.
Do not smoke while charging the batteries.
While charging the battery, always keep the tank assembly open with the relevant stand (25).
WARNING!
Pay careful attention when charging the batteries as there may be battery fl uid leakages. The battery fl uid is
corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.
Preliminary procedures
Drive the machine on a level fl oor.1.
Open the cover (20) and check that the tank (19) is empty, otherwise empty it with the drain hose (24).2.
Close the cover (20).3.
Carefully lift the tank assembly (44).4.
(For WET batteries only) Check the level of electrolyte inside the batteries (39). If necessary, unscrew the plugs (40) and top 5.
up.
When the correct level is reached, close the caps (40) and, if necessary, clean the upper surface of the batteries.
Battery charging
Connect the battery charger cable (41) to the electrical mains (the electrical mains voltage and frequency must be compatible 6.
with the battery charger values shown on the machine serial number plate).
NOTE
When the battery charger is connected to the electrical mains, all machine functions are automatically cut off.
The red warning light (62) is on when the battery charger is charging the batteries.
The yellow warning light (62) is on when the battery charger is completing the battery charging.
When the green warning light turns on, the battery charging is completed.4.
When the battery charging is completed, disconnect the battery charger cable (41) from the electrical mains and wind it round 5.
its housing behind the battery charger.
Carefully lower the tank assembly (44). 6.
Now the machine is ready to be used.7.
NOTE
For further information about the battery charger operation (16), see the relevant Manual.
To Next Page
Loading...
Need help?
General
