EasyManuals Logo

Nilfisk-Advance SC4000 User Manual

Nilfisk-Advance SC4000
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
A - 32 Advance SC4000 - 56091272 9/2022
INSTRUCTIONS FOR USEA - ENGLISH
AFTER USE
1 When nished scrubbing, press the One-Touch Scrub Switch (M). This will automatically raise, retract and stop all the machine systems
(brush, squeegee, vacuum, solution and detergent (with EcoFlex)). Then drive the machine to a service area for daily maintenance and
review of other needed service up keep.
2 To empty the solution tank;
• Solution tank only needs to be emptied daily if detergent was mixed in the tank. Solution tank should also be emptied if machine is to be
transported or stored for more than a few days.
• Move the machine over a designated “DISPOSAL SITE”.
• If equipped, remove the optional Solution Drain Hose (13) from its storage clamp under the front bumper then remove the plug.
• Rotate the handle on the Solution Shutoff Valve (37) to lie over the drain side of the valve.
• Rinse the tank with clean water if detergent was used in the tank.
• Rotate the handle on the Solution Shutoff Valve (37) to lie over the solution lter side of the valve.
3 To empty the recovery tank;
• Pull the Recovery Tank Drain Hose (28) from its storage area.
• Direct the hose to a designated “DISPOSAL SITE” and unscrew the cap (hold the end of the hose above the water level in the tank to avoid
sudden, uncontrolled ow of waste water). The Recovery Tank Drain Hose can be squeezed to regulate the ow. Lower and release the hose
to drain the tank.
• Open the Recovery Tank Cover (1).
• Empty and rinse the Debris Catch Tray (27) in the recovery tank.
• Thoroughly rinse the recovery tank with clean water, see “Cleaning Recovery Tank” section.
4 Inspect the recovery and vacuum hoses; replace if kinked or damaged.
5 Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.
6 Remove the squeegee, rinse it with warm water and re-install on mount or hang it from the back of the recovery tank.
7 Remove the hopper on cylindrical systems and clean thoroughly. Remove from either side of the machine by tilting the hopper up and away
from housing, then pull out.
8 Check the maintenance schedule below and perform any required maintenance before storage.
9 Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.
10 Turn the machine off by pressing the Power Switch (H) and then remove the magnetic key.
11 Batteries are the most expensive replacement item on this machine. To protect your investment and to get as many cycles from the batteries
as possible, remember the following:
Batteries will last longer if kept fully charged.
Battery chargers will not over or undercharge the batteries.
Batteries will prematurely fail if stored in a discharged state.
Every day after use, the battery charger must be plugged in and the charger must be allowed to run through a full charging sequence to
fully charge the batteries.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance SC4000 and is the answer not in the manual?

Nilfisk-Advance SC4000 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelSC4000
CategoryScrubber
LanguageEnglish

Related product manuals