EasyManuals Logo

Nilfisk-Advance SC450 User Manual

Nilfisk-Advance SC450
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
USER MANUAL ENGLISH
9099596000 - SC450 13
MACHINE OPERATION (SCRUBBING/DRYING)
1. Start the machine as shown in the previous paragraph.
2. While keeping both hands on the handlebar (2), press the push-button (43), then manoeuvre the machine and start scrubbing/
drying the oor.
3. If necessary, stop the machine and adjust the squeegee balancing handwheel (23).
4. If necessary, adjust the solution quantity by using the valve (36).
CAUTION!
To avoid any damage to the oor surface, turn off the brush/pad-holder when the machine stops in one place.
CAUTION!
Before lifting the brush/pad, turn it off by releasing the push-button (43).
NOTE
For correct scrubbing/drying of oors at the sides of the walls, Nilsk suggests to go near the walls with the right side of
the machine as shown in gure 2.
B
A
Figure 2
P100664
Machine speed adjustment
5. The machine speed varies according to the type of oor to be cleaned and the choice of using the brush or the pad. If
necessary, stop the machine and turn the forward speed adjusting handwheel (25) as shown below:
Turn it counter-clockwise to increase the forward speed;
Turn it clockwise to decrease the forward speed.
Machine straight-forward drive
6. If it is difcult to keep the machine moving straight-forwardly because it deviates to the left or to the right, adjust the handwheel
(24) by turning it clockwise or counter-clockwise.
MACHINE TRANSPORT/PARKING
To transport/park the machine, proceed as follows.
1. Turn the brush/pad-holder switch and the vacuum system switch (41 and 42) to “0”.
2. Disconnect the power supply cable plug (4) from the electrical mains and place it on the holder (5).
3. Lift the squeegee (21) with the lever (7).
4. Grab the handlebar (2) and slightly lower it until the brush lifts from the oor. While holding the machine in this position, drive
it to the appointed parking area. Then lower the machine until the rear wheel (6) comes into contact with the oor (parking
position (27)).
5. When nishing working, remove the brush/pad-holder (see the procedure in Maintenance chapter).

Table of Contents

Other manuals for Nilfisk-Advance SC450

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance SC450 and is the answer not in the manual?

Nilfisk-Advance SC450 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelSC450
CategoryScrubber
LanguageEnglish

Related product manuals