To Next PageTo Next Page
Need help?Do you have a question about the Nilfisk-ALTO Scrubtec R 6-71C 28C and is the answer not in the manual?
General| Brand | Nilfisk-ALTO |
|---|---|
| Model | Scrubtec R 6-71C 28C |
| Category | Floor Machine |
| Language | English |
Manual details machine operation, component locations, troubleshooting, maintenance, and service.
Explains safety symbols and their meanings.
Explains safety symbols and their meanings.
Provides essential safety guidelines for operating and servicing.
Lists technical data and dimensions for various models.
Outlines routine maintenance tasks and their intervals.
Checklist for operational and visual inspection items.
Describes the functions of various buttons and indicators on the control panel.
Guides on programming controller parameters for specific functions.
Instructions on accessing and using the machine's hidden menu system.
Accessing a mode to test motors and solenoids.
Guidance on interpreting error codes displayed on the panel.
Lists and explains error codes generated by the main controller.
Comprehensive table of controller pin designations, types, and functions.
Step-by-step guide for replacing the main control board.
Explains the series of switches that ensure safe operation.
Procedures for charging and maintaining machine batteries.
Safety precautions and procedures for charging batteries.
Tips for maximizing the lifespan of machine batteries.
Methods for diagnosing battery health issues.
Detailed instructions for battery replacement.
Electrical schematic for early model wiring, part 1.
Electrical schematic for early model wiring, part 2.
Procedure to test static pressure and flow rate of the vacuum system.
Step-by-step guide for removing the recovery tank.
Procedure for removing and servicing the vacuum motor assembly.
Detailed steps for adjusting the actuator's travel limits.
Step-by-step guide for replacing these components.
Procedure for removing and replacing the detergent pump.
Procedures for cleaning, inspecting, and adjusting squeegee blades.
Steps for cleaning and checking squeegee blade condition.
How to adjust the squeegee for proper floor contact.
Procedure for adjusting the limit switches of the squeegee lift actuator.
Procedures for removing and replacing the rear squeegee blade.
Step-by-step guide for blade reversal or replacement.
Procedure for replacing the front squeegee blade.
Procedure for removing and reinstalling the squeegee lift actuator.
Common problems and their solutions for the drive system.
Lists and explains error codes from the drive controller.
Steps for removing and replacing the main drive controller unit.
Steps for removing the drive wheel assembly from the machine.
Procedures for removing the drive motor and brake components.
Procedure for replacing the drive tire using a puller kit.
