10 11ninjakitchen.com
6 Holding the Stacked Blade Assembly
by the top of the shaft, place it onto
the gear shaft inside the pitcher. Ensure
the Stacked Blade Assembly is seated
properly and is standing upright.
7 Add the ingredients to the pitcher,
making sure they do not exceed the
highest measured marking line on the
side of the pitcher.
8 Holding the lid by the handle in the
upright position, place it on top of the
pitcher, aligning the arrow (
) located on
the lid with the arrow ( ) located on the
pitcher’s handle. Press the handle down
until you hear a click. The triangles on the
lid and pitcher handle MUST be aligned for
the blender to turn on.
11ninjakitchen.com
BEFORE FIRST USE
IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
DID YOU KNOW?
• You can take your drinks on the go using
the spout lid.
• The cup, lid, and blade assembly are BPA
free and dishwasher safe.
NOTE: The Stacked Blade Assembly
will fit loosely on the drive gear.
1 Remove all packaging material and
labels from the appliance. Separate/
remove all parts from each other.
2 Wash the lids, pitcher, Nutri Ninja
®
Cups and blade assemblies in warm,
soapy water. When washing the blade
assemblies, use a dishwashing utensil
with a handle to avoid direct hand
contact with blades.
3 Handle blade assemblies with care to
avoid contact with sharp edges. Rinse
and air dry thoroughly.
4 The pitcher, Nutri Ninja cups, lids, and
blade assemblies are all dishwasher
safe. It is recommended that the
lids and blades be placed on the top
rack. Ensure the blade assemblies are
removed from the containers before
placing in the dishwasher.
5 Wipe the motor base clean with a
damp cloth.
NOTE: All attachments are dishwasher
safe. It is recommended that the cup,
lid, and blade assembly be placed
on the top rack of the dishwasher.
Ensure blade assembly and lid are
removed from the cup before placing
in the dishwasher. Exercise care
when handling blade assembly. Make
sure Flip & Seal Lid is open during
dishwasher cycle.
1 Review warning and caution statements
above before proceeding to Step 2.
2 Place the motor base on a clean, dry,
level surface such as a counter or table. .
3 Align and lower the pitcher onto the
motor base. Handle should be aligned
slightly to the right of the “LOCK”
symbol on the motor base.
4 Rotate the pitcher clockwise until it locks
in place. As the pitcher rotates, it will
lower and the safety tabs on the bottom
of the pitcher will slide under the safety
tabs on the top of the motor base.
5 The pitcher can be placed on the motor
base two ways; the handle can be on the
front right corner or the front left corner.
ASSEMBLY & USE OF THE PITCHER
NOTE: If you need to add additional
ingredients while the appliance is
blending, open the pour spout cap
and pour the ingredients in through
the opening.
NOTE: When blending any kind of
liquids, such as drinks or smoothies,
do not exceed the “Max Liquid” mark
(1.9 L) on the pitcher.
To Next Page
Loading...
Need help?
General
