12 13ninjakitchen.com
1 Review warning and caution statements
above before proceeding to Step 2.
2 Place the motor base on a clean, dry,
level surface such as a counter or table. .
3 Add ingredients to the Nutri Ninja Cup.
4 Place the Pro Extractor Blades®
Assembly onto the cup and turn it
clockwise until you have a good seal.
5 Turn the Nutri Ninja Cup upside down
and place it onto the motor base,
aligning the tabs on the cup with the
motor base. Turn clockwise until you
hear a click, then the unit is ready for
use.
6 Plug the power cord into an electrical
outlet and press the Power button ( ).
13 When you have reached your desired
consistency, stop the appliance by
pressing the Power button (
) and wait
for the Stacked Blade Assembly to
stop turning.
14 Turn the pitcher counterclockwise and
then lift it o the base.
15 Open the pour spout cap and use the
spout to empty contents.
16 For thicker consistencies, first remove
the lid by pressing the release button
and pulling the lid handle up to a 90
degree angle to lift lid o the pitcher.
Then, carefully remove the Stacked
Blade Assembly by the top of the
shaft. Place Stacked Blade Assembly
away from the work area to avoid
accidental contact. Finally, empty
contents from the pitcher.
17 Make sure the unit is unplugged when
not in use.
9 Plug the power cord into an electrical
outlet and press the power button ( ).
10 Review warning and caution statements
on page 8 before proceeding to Step 11..
11 Select the speed that best suits your
needs.
12 If the ingredients stick to the side of
the pitcher, stop the appliance by
pressing the Power button ( ) and
wait for the Stacked Blade Assembly
to stop turning. Then remove the lid
by pressing the release button, lifting
the handle, and pulling straight up.
Use a rubber spatula to dislodge
the ingredients, replace the lid, and
continue processing.
ASSEMBLY & USE OF THE PITCHER – CONT� ASSEMBLY & USE OF THE NUTRI NINJA® CUP
IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
IMPORTANT: As a safety feature, the
Power button ( ) will flash and the
motor will not start if the pitcher and
lid are not installed correctly. When the
pitcher and lid are installed properly,
the Power button ( ) will be solid,
indicating the blender is ready for use.
WARNING: Never insert your hands
in the pitcher as the Stacked Blade
Assembly is sharp. Always use a spatula
to dislodge ingredients that has stuck
to the sides of the pitcher.
NOTE: Pulse ingredients for even
chopping by pressing the PULSE button
in short intervals.
7
Press down on the PULSE button in short
intervals to pulse. Press the Nutri Ninja
button to activate the run cycle. The
blender will stop after 60 seconds. To
stop at any time during the cycle, press
the Nutri Ninja button a second time or
press the Power button ( ).
8 Once you have reached your desired
consistency, stop the appliance by
pressing the Power button and wait
for the blade to stop turning. Turn the
Nutri Ninja Cup counterclockwise and
pull straight up to remove.
9 Turn the cup upright and remove the
Pro Extractor Blades Assembly by
twisting blade assembly counterclockwise.
10 Do not store blended contents with the
blade assembly attached.
11 Place the To-Go Lid on the Nutri Ninja
cup and twist clockwise to seal.
12 Be sure to store the Pro Extractor Blades
attached to an empty cup when not in use.
13 Make sure the motor base is unplugged
when not in use.
NOTE: Do not overfill! To avoid spilling,
do not add ingredients past the “Max”
fill line.
To Next Page
Loading...
Need help?
General
