Page | 12
c. Step 2: Place sensors on top of the PN3 eva soft case. The location of the kit during this
process should be in the middle of the motion capture space.
d. Step 3: A critical step that performs four operations to prepare your sensors for motion
capture.
i. Sensor Count: Assumming sensors are on, sensor count will alert you if any
sensors are not connecting.
ii. Sensor Initialization: Performs Standard and Magnetic Simplified Calibration
iii. Signal Quality: Test signal quality. Must be above 90%
iv. Sensor Posture: Magnetic Status check
To Next Page
Loading...