"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Events and Logs
Issue: 10 3HH-11982-AAAA-TQZZA 131
6.8.6.2 log-id
Table 124 log-id command
Description This command selects the source stream to be sent to a log destination.
One or more source streams must be specified. The source of the data stream must be
identified using the from command before you can configure the destination using the to
command. The from command can identify multiple source streams in a single statement (for
example: from main change debug-trace).
Only one from command may be entered for a single log-id. If multiple from commands are
configured, then the last command entered overwrites the previous from command.
The no form of the command removes all previously configured source streams.
Default No source stream is configured.
Parameters main — Instructs all events in the main event stream to be sent to the destination defined in
the to command for this destination log-id. The main event stream contains the events that are
not explicitly directed to any other event stream. To limit the events forwarded to the
destination, configure filters using the filter (log destination) command.
security — Instructs all events in the security event stream to be sent to the destination
defined in the to command for this destination log-id. The security stream contains all events
that affect attempts to breach system security such as failed login attempts, attempts to access
MIB tables to which the user is not granted access or attempts to enter a branch of the CLI to
which access has not been granted. To limit the events forwarded to the destination, configure
filters using the filter (log destination) command.
change — Instructs all events in the user activity stream to be sent to the destination
configured in the to command for this destination log-id. The change event stream contains all
events that directly affect the configuration or operation of this node. To limit the events
forwarded to the change stream destination, configure filters using the filter (log destination)
command.
debug-trace — Instructs all debug-trace messages in the debug stream to be sent to the
destination configured in the to command for this destination log-id. Filters applied to debug
messages are limited to application and subject.
Item Description
(2 of 2)
Item Description
Syntax [no] log-id log-id
Context configure>log
Description This command creates a context to configure destinations for event streams.
The log-id context is used to direct events, and debug information to respective destinations.
Before an event can be associated with this log-id, the from command identifying the source
of the event must be configured.
Only one destination can be specified for a log-id.
Log-IDs 99 and 100 are created by the agent. Log-ID 99 captures all log messages.
Log-ID 100 captures log messages with a severity level of major and above.
The no form of the command deletes the log destination ID from the configuration. The default
System logs (Log-IDs 99 and 100) cannot be deleted using the no form of the command.
(1 of 2)
To Next Page
Loading...
