Nokia 7302 - Event-Control; Show Commands; Table 125 to Command; Table 126 Event-Control Command

Events and Logs
132
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
6.8.6.3 to
Table 125 to command
6.8.7 Show Commands
6.8.7.1 event-control
Table 126 event-control command
Default No log destinations are defined.
Parameters log-id — The log ID number, expressed as a decimal integer.
Values: 1 — 100
Item Description
(2 of 2)
Item Description
Syntax to session
Context configure>log>log-id log-id
Description This command specifies a log ID destination. This parameter is mandatory when configuring a
log destination. This command instructs the events selected for the log ID to be directed to the
current CLI session. This command is only valid for the duration of the session. When the
session is terminated the log ID is removed. A log ID with a session destination is not saved in
the configuration file.
The source of the data stream must be specified in the from command prior to configuring the
destination with the to command.
Default None
Item Description
Syntax event-control [application-id [event-name | event-number]
Context show>log
Description Displays event control settings for events including whether the event is suppressed or
generated and the severity level for the event.
If no options are specified all events, alarms and traps are listed.
(1 of 2)