"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Tools
Issue: 10 3HH-11982-AAAA-TQZZA 137
7 Tools
7.1 Tools CLI Command Reference
7.2 Tools CLI Configuration Commands
7.1 Tools CLI Command Reference
This section shows the following command hierarchies:
• Tools Dump Commands
• Tools Perform Commands
7.1.1 Tools Dump Commands
tools
— dump
— eth-ring <ring-index> clear
— lag lag-id lag-id
— persistence
— submgt
— summary
— router [router-instance]
— fib
— jumbo-frame
— non-protocol-counter
— protocol-counter
— ldp
— fec prefix ip-prefix/mask
— fec vc-type {ethernet | vlan} vc-id vc-id
— instance
— interface [ip-int-name | ip-address]
— memory-usage
— peer ip-address
— session [ip-addr[:label-space] [connection | peer | adjacency]
— sockets
— timers
— mpls
— ftn [endpoint endpoint | sender sender | nexthop nexthop | lsp-id lsp-id |
tunnel-id tunnel-id | label start-label end-label]
— ilm [endpoint endpoint | sender sender | nexthop nexthop | lsp-id lsp-id |
tunnel-id tunnel-id | label start-label end-label]
— lspinfo
— memory-usage
— ospf ospf-instance
— abr [detail]
— asbr [detail]
— bad-packet interface-name
— leaked-routes [summary | detail]
— memory-usage [detail]
— request-list [neighbor ip-address] [detail]
— request-list virtual-neighbor ip-address area-id area-id [detail]
— retransmission-list [neighbor ip-address] [detail]
— retransmission-list virtual-neighbor ip-address area-id area-id [detail]
— route-summary
— route-table [type] [detail]
— ospf3 ospf-instance
— abr [detail]