Nokia 7302 - Dst-Ip; Dst-Port; Table 61 Dst-Ip Command; Table 62 Dst-Port Command

Security
64
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
4.4.2.25 dst-ip
Table 61 dst-ip command
4.4.2.26 dst-port
Table 62 dst-port command
Item Description
Syntax [no] dst-ip {ipv6-address[/prefix-length]
Context configure>system>security>cpu-filter>ipv6-filter>entry>match
Description This command matches a destination IPv6 address.
To match on the destination IP address, specify the address and prefix length. For example,
11::12/128.
The no form of the command removes the destination IP address match criterion.
Default None
Parameters ipv6-address — The IPv6 address for the IP match criterion in dotted decimal notation.
Values: : ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces) x:x:x:x:x:x::d.d.d.d where:
• x = [0..FFFF]H
• d = [0..255]D
prefix-length — The IPv6 prefix length for the ipv6-address expressed as a decimal integer.
Values: (1..64)
Item Description
Syntax [no] dst-port [dst-port-number] [mask]
Context configure>system>security>cpu-filter>ipv6-filter>entry>match
Description This command configures a destination TCP or UDP port number for an IPv6 filter match
criterion.
The no form of the command removes the destination port match criterion.
Default None
Parameters dst-port-number — The destination port number to be used as a match criteria expressed as
a decimal, hex or binary integers.
Values: 0 — 65535
mask— Mask used to specify a range of destination port numbers as the match criterion.