"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Monitor Commands
Issue: 10 3HH-11982-AAAA-TQZZA 77
5 Monitor Commands
5.1 Monitor Commands
5.2 Monitor CLI Command Reference
5.3 Monitor CLI Commands
5.1 Monitor Commands
Monitor commands display specified statistical information related to the monitor
subject (such as filter, port, lag, router) at a configurable interval until a count is
reached. The CLI monitor commands are found in the root>monitor context of the
CLI tree.
The monitor command output displays a snapshot of the current statistics. The
output display refreshes with subsequent statistical information at each configured
interval and is displayed as a delta to the previous display.
The <Ctrl-c> keystroke interrupts a monitoring process. Monitor command
configurations cannot be saved. You must enter the command for each monitoring
session. Note that if the maximum limits are configured, you can monitor the
statistical information for a maximum of 60 × 999 sec = ~ 1000 minutes.
The CLI monitor command contexts are listed in Table 89.
Table 89 CLI Monitor Command Contexts
5.2 Monitor CLI Command Reference
Command Description
filter Enables IP and MAC filter monitoring at a configurable interval until that count is reached
lag Enables Link Aggregation Group (LAG) monitoring to display statistics for individual port
members and the LAG
port Enables port traffic monitoring. The specified port(s) statistical information displays at the
configured interval until the configured count is reached
router Enables virtual router instance monitoring at a configurable interval until that count is reached
To Next Page
Loading...
