Nokia 7302 - Page 95

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Monitor Commands
Issue: 10 3HH-11982-AAAA-TQZZA 95
Sample output:
A:ALA-12>monitor>router>ldp# statistics interval 5 repeat 3 absolute
============================================================================
Monitor statistics for LDP instance
============================================================================
At time t = 0 sec (Base Statistics)
----------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 1 Serv FECs Recv : 2
----------------------------------------------------------------------------
At time t = 5 sec (Mode: Absolute)
----------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 1 Serv FECs Recv : 2
----------------------------------------------------------------------------
At time t = 10 sec (Mode: Absolute)
----------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 1 Serv FECs Recv : 2
----------------------------------------------------------------------------
At time t = 15 sec (Mode: Absolute)
----------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 1 Serv FECs Recv : 2
============================================================================
A:ALA-12>monitor>router>ldp#
A:ALA-12>monitor>router>ldp# statistics interval 5 repeat 3 rate
============================================================================
Monitor statistics for LDP instance
============================================================================
Description Monitor statistics for LDP instance at the configured interval until the configured count is
reached.
The first screen displays the current statistics related to the specified router statistics. The
subsequent statistical information listed for each interval is displayed as a delta to the previous
display.
When the rate keyword is specified, the “rate per second” for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of times
at the interval specified.
Parameters interval seconds — Configures the interval for each display in seconds.
Default: 10 seconds
Values: 5 — 60
repeat repeat — Configures how many times the command is repeated.
Default: 10
Values: 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Item Description
(2 of 2)